How to check Complete Model SM-J710FN and Current Firmware

1. Go to Settings
2. Than Tap on About
3. Here you can see Model Number: SM-J710FN
4. For example: SM-J710FN
5. For example: Android Nougat 7.0

The latest 10 updates for Samsung Galaxy J7 (2016)

When the Galaxy J7 (2016) Oreo update is available as an OTA isn’t clear though, as Samsung hasn’t announced its 8.0 update plans yet. As of October 18, Samsung’s Oreo for S8 isn’t live either, so it’s hard to tell when company would have its first Oreo build ready, which will enter beta testing first, and then be released as stable update but if samsung start sending the Oreo update to Galaxy J7 (2016) you will see the update in table The latest 10 updates for Samsung In fact many Samsung devices will not get the updated Oreo Android 8 Let's not anticipate events and wait for what Samsung will do.

Warning

Step 1 : Download firmware update J710FNDDU1BRB2 to Galaxy J7 (2016) model SM-J710FN

More Updates and Related Post

Step 2 : Installing Official Firmware J710FNDDU1BRB2 Android Nougat 7.0 on Galaxy J7 (2016) model SM-J710FN through Odin

• Remember : This guide is to Install latest update J710FNDDU1BRB2 update on Galaxy J7 (2016) model SM-J710FN .
• Your device must have 70% Of battery.
• You need a Laptop or PC to perform this Action.
• You should be using Stock Firmware and not Custom ROM
• Back Up your Data to make sure you have data’s in case if something Wrong (This Process won’t loose your data)
• Make sure you have followed the steps properly. Don’t Skip and Read ! – We are not responsible for any damage that you make to your Phone.

• Download and Install the Samsung Kies Software :  CLICK HERE
• Download and Install the Samsung USB Drivers :  CLICK HERE
• Download and Extract the ODIN ZIP file on Desktop :  CLICK HERE

1. If you have downloaded and installed the file from above then you are good to Go – Read from Step 2
   • First of all, enable the USB Debugging
   • To Enable the USB Debugging you need also active the developer option, Now Go to your Settings -> About Phone -> Now Tap on the Build Number 7-8 Times until you see a toast message “Developer option enabled“
   • Once your developer option is active, Go back to your settings -> Open developer option -> Enable USB Debugging 
2. Open the Extracted ODIN File called ODIN v3.12.7 exe or any versions of odin file using the Administrator – Right Click your mouse and Open using Administrator 
3. Now Reboot your Phone into Download Mode
4. So First Turn your Phone off -> press and hold Home + Power + Volume Down buttons Until you see a download mode.
5. Now Connect your Phone to PC using the USB Cables
6. When you connect the USB cable you will see a blue sign in Odin
7. Now Go back again Odin and Add the firmware which you downloaded from Above by Clicking AP/PDA Button 
8. Now Make sure re-partition is NOT ticked – Go to Option and see (Let the Auto Reboot and F-Reset Time be ticked)
9. Click the start button, sit back and wait few minutes until you see a message pass. Once you see PASS then you can remove your Phone from the part. Don’t Panic if you see your Phone restarts while updating.