How to check Complete Model SM-J600G and Current Firmware

1. Go to Settings
2. Than Tap on About
3. Here you can see Model Number: SM-J600G
4. For example: SM-J600G
5. For example: Android pie 9

All Country have got Update J600GUBS6BTC2 for Samsung Galaxy J6 SM-J600G

This is the only "state" area that has been updated so far

Warning

Step 1 : Download firmware update J600GUBS6BTC2 to Galaxy J6 model SM-J600G

More Updates and Related Post

Step 2 : Installing Official Firmware J600GUBS6BTC2 Android pie 9 on Galaxy J6 model SM-J600G through Odin

• Remember : This guide is to Install latest update J600GUBS6BTC2 update on Galaxy J6 model SM-J600G .
• Your device must have 70% Of battery.
• You need a Laptop or PC to perform this Action.
• You should be using Stock Firmware and not Custom ROM
• Back Up your Data to make sure you have data’s in case if something Wrong (This Process won’t loose your data)
• Make sure you have followed the steps properly. Don’t Skip and Read ! – We are not responsible for any damage that you make to your Phone.

• Download and Install the Samsung Kies Software :  CLICK HERE
• Download and Install the Samsung USB Drivers :  CLICK HERE
• Download and Extract the ODIN ZIP file on Desktop :  CLICK HERE

1. If you have downloaded and installed the file from above then you are good to Go – Read from Step 2
   • First of all, enable the USB Debugging
   • To Enable the USB Debugging you need also active the developer option, Now Go to your Settings -> About Phone -> Now Tap on the Build Number 7-8 Times until you see a toast message “Developer option enabled“
   • Once your developer option is active, Go back to your settings -> Open developer option -> Enable USB Debugging 
2. Open the Extracted ODIN File called ODIN v3.12.7 exe or any versions of odin file using the Administrator – Right Click your mouse and Open using Administrator 
3. Now Reboot your Phone into Download Mode
4. So First Turn your Phone off -> press and hold Home + Power + Volume Down buttons Until you see a download mode.
5. Now Connect your Phone to PC using the USB Cables
6. When you connect the USB cable you will see a blue sign in Odin
7. Now Go back again Odin and Add the firmware which you downloaded from Above by Clicking AP/PDA Button 
8. Now Make sure re-partition is NOT ticked – Go to Option and see (Let the Auto Reboot and F-Reset Time be ticked)
9. Click the start button, sit back and wait few minutes until you see a message pass. Once you see PASS then you can remove your Phone from the part. Don’t Panic if you see your Phone restarts while updating.